LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2010 >> Acadia SLE, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 181 (Engine Mechanical - 2.8L Or 3.0L - Repair Instructions - Off Vehicle (4 Of 5)) >> Camshaft Cover Installation - Left Side (LAU or LBW) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Spark Plug Tubes
    GM1832346Courtesy of GENERAL MOTORS CORP.
  1. Install the EN 46101:  guide onto the spark plug tubes of the cylinder head bank 2.
    2. Fig 2: Identifying Camshaft Cover Bolt Grommets
    GM1864464Courtesy of GENERAL MOTORS CORP.
  2. Install the NEW camshaft cover bolt grommets prior to installing the camshaft cover bolts.
  3. Wipe the camshaft cover sealing surface on the right cylinder head with a clean, lint-free cloth.
    4. Fig 3: Locating Engine Front Cover Split Lines
    GM1832348Courtesy of GENERAL MOTORS CORP.
  4. Place a bead 8 mm (0.3150 in) in diameter by 4 mm (0.1575 in) in height of RTV sealant on the engine front cover split lines (1). Refer to Adhesives, Fluids, Lubricants, and Sealers for the recommended sealant.
    5. Fig 4: View Of Camshaft Cover - Left Side (LAU)
    GM2026524Courtesy of GENERAL MOTORS CORP.
  5. Install the camshaft cover from the cylinder head bank 2.
  6. Loosely install the 13 camshaft cover bolts bank 2 (1).
    7. Fig 5: Identifying Left Camshaft Cover Bolt Tightening Sequence
    GM1864541Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  7. Tighten the 13 camshaft cover bolts bank 2 in the sequence shown (1-13):
    1. Tighten the camshaft cover bolts bank 2 in the first sequence to 10 N.m (89 lb in) .
    2. Tighten the camshaft cover bolts bank 2 a second pass in sequence to 10 N.m (89 lb in) .
    8. Fig 6: Identifying Spark Plug Tubes
    GM1864542Courtesy of GENERAL MOTORS CORP.
  8. Remove the EN 46101:  guide from the spark plug tubes of the cylinder head bank 2.
    9. Fig 7: Identifying Spark Plugs
    GM1864416Courtesy of GENERAL MOTORS CORP.
  9. Install the NEW spark plugs into the cylinder head 2 and tighten to 20 N.m (15 lb ft).
    10. Fig 8: Identifying Ignition Coils & Bolts
    GM2026523Courtesy of GENERAL MOTORS CORP.
  10. Install the 3 ignition coils (2).
  11. Install the 3 ignition coil bolts (1) and tighten to 10 N.m (89 lb in).
scientia non olet · About LEMON Manuals