LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2009 >> Acadia SLT, FWD >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 6T75 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Transmission Mount Replacement - Left Side >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Transmission Mount & Bracket
    GM2003344Courtesy of GENERAL MOTORS CORP.
  1. Install the transmission mount (2) and bracket (1) to the vehicle.
    2. Fig 2: View Of Transmission Mount Bracket Bolts
    GM2003343Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  2. Install the transmission mount bracket bolt (3) and tighten to 90 N.m (66 lb ft).
  3. Install the transmission mount bracket bolt (1) and tighten to 90 N.m (66 lb ft).
  4. Using the transmission jack, lower the transmission until the transmission mount bracket rests on the transmission mount.
  5. Install the transmission mount bracket bolt (2) and tighten to 90 N.m (66 lb ft).
  6. Remove the transmission jack.
    7. Fig 3: Identifying Transmission Mount Nuts
    GM2003342Courtesy of GENERAL MOTORS CORP.
  7. Install the transmission mount nut (2) and tighten to 75 N.m (55 lb ft).
  8. Install the transmission mount nut (1) and tighten to 90 N.m (66 lb ft).
  9. Install the left engine splash shield. Refer to Engine Splash Shield Replacement .
  10. Lower the vehicle
scientia non olet · About LEMON Manuals