Channel Plate and Upper Channel Plate Assemble
Channel Plate and Upper Channel Plate Assemble
| Callout | Component Name |
|---|---|
| 1 | Control Valve Channel Upper Plate Assembly Tip: Inspect the upper channel plate bolt pass through holes for damage or burnelling. Any damage near the PCS feed holes could cause leaking around the PCS switch seal. Replace as necessary. |
| 2 | Control Valve Body Bolt M6 x 35 (Qty: 3)
CAUTION:
Refer to Fastener Caution
.
Tighten: Hand tighten for alignment, then tighten in sequence to 12 N.m (9 lb ft) after all bolts are installed. |
| 3 | Control Valve Body Bolt M6 x 65 (Qty: 5) Tighten: Tighten in sequence to 12 N.m (9 lb ft). |
| 4 | Control Valve Body Bolt M6 x 55 (Qty: 2) Tighten: Tighten in sequence to 12 N.m (9 lb ft). |