Spring Bumper Replacement (2WD, Z85, ZQ8)

Spring Bumper Replacement (2WD, Z85, ZQ8)

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair) .




2. Remove the jounce bumper mounting bolts.
3. Remove the jounce bumper.

Installation Procedure




1. Install the jounce bumper.

Notice: Refer to Fastener Notice (Fastener Notice) .

2. Install the jounce bumper bolts.

Tighten the bolt to 32 N.m (24 lb ft).

3. Lower the vehicle.