Spring Shackle Replacement

Spring Shackle Replacement

Tools Required

J 36660-A Angle Meter

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair) .




2. Support the rear axle at ride height.
3. Remove the shackle nut and the bolt from the frame.
4. Remove the shackle nut and the bolt from the spring.
5. Remove the shackle assembly from the vehicle.

Installation Procedure




1. Install the shackle assembly to the spring.
Notice: Refer to Fastener Notice (Fastener Notice) .

2. Install the shackle nut and bolt to the spring.

Tighten the rear shackle nut to 85 N.m (63 lb ft).

3. Install the shackle nut and bolt to the frame

Tighten the shackle nut to 85 N.m (63 lb ft).

4. Remove the rear axle support.
5. Lower the vehicle.