Parking Brake Warning Switch: Service and Repair

Parking Brake Indicator Switch Replacement

Removal Procedure




1. Remove the knee bolster trim panel. Refer to Knee Bolster Replacement (Service and Repair) .




2. Remove the electrical connector.




3. Remove the park brake warning lamp switch mounting bolt.




4. Remove the park brake warning lamp switch from the vehicle.

Installation Procedure




1. Install the park brake warning lamp switch.





Notice: Refer to Fastener Notice.

2. Install the park brake warning lamp switch mounting bolt.

Tighten the park brake warning lamp switch mounting bolt to 4 N.m (35 lb in).




3. Install the electrical connector.




4. Install the knee bolster trim panel. Refer to Knee Bolster Replacement (Service and Repair) .