LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2008 >> Canyon 2D Pickup, 2.9 9, 4WD, Automatic >> Labor Times >> Brakes >> Mechanical - Hydraulic >> Brake Shoes &/Or Pads >> Remove & Replace

Brake Shoes &/Or Pads: Remove & Replace

Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishing.

Applies ToNoteStandard HoursWarranty HoursSkill Level
All2.2B
Front,Pads1.0B
Rear,Shoes1.4B
Combination Procedure: AXLE BEARING: Replace:
Rear,Both1.2B
Rear,One Side1.0B
Combination Procedure: AXLE SEAL: Replace:
Semi-Floating Axle.
Rear,Both1.1B
Rear,One Side0.9B
Combination Procedure: BRAKE HOSE: Replace:
Each AdditionalIncludes: Perform ABS Automated Bleed procedure.0.2B
OneIncludes: Perform ABS Automated Bleed procedure.1.1B
Combination Procedure: CALIPER: Overhaul:
One,Dual PistonIncludes: Perform ABS Automated Bleed procedure.1.5B
Combination Procedure: CALIPER: Replace:
OneIncludes: Perform ABS Automated Bleed procedure.0.7B
Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle:
0.5B
Combination Procedure: DISC ROTOR: Remove and Install for Refinishing:
4WD, Front,Each2.2B
Combination Procedure: DISC ROTOR: Replace:
4WD, Front,Each2.2B
Combination Procedure: WHEEL BEARING: Replace:
4WD, Front,One Side2.2B
Combination Procedure: WHEEL CYLINDER: Overhaul:
One,Off VehicleIncludes: Perform ABS Automated Bleed procedure.1.0B
One,On VehicleIncludes: Perform ABS Automated Bleed procedure.0.8B
Combination Procedure: WHEEL CYLINDER: Replace:
OneIncludes: Perform ABS Automated Bleed procedure.0.8B