Rear Quarter Lower Trim Panel Replacement (Enclave with E61)

Fig 1: Identifying Rear Quarter Lower Trim Panel (Enclave With E61)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Move the rear seat to the full forward position. Remove the rear number 2 seat. Refer to Rear Number 2 Seat Replacement . Remove the rear quarter upper trim panel. Refer to Rear Quarter Upper Trim Panel Replacement (without RPO E61) or Rear Quarter Upper Trim Panel Replacement (with RPO E61) . Disconnect the liftgate actuator rod from the liftgate. Refer to Liftgate Actuator Rod Replacement . Disconnect the rear seat number 2 shoulder belt anchor bolt. Refer to Rear Seat Number 2 Retractor Side Belt Replacement .
1	Cargo Tie Down Loop Bolt Cap (Qty: 2)
2	Cargo Tie Down Loop Bolt (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 3 N.m (27 lb in)
3	Cargo Tie Down Loop (Qty: 2)
4	Body Side Trim Panel Armrest Tip: Pull upward on the armrest to disengage the retainer clips.
5	Cargo Screen Retainer Assembly Tip: Twist and pull outward to remove the retainer.
6	Rear Quarter Lower Trim Panel Bolt (Qty: 2) Tighten: 3 N.m (27 lb in)
7	Rear Quarter Lower Trim Panel Assembly Procedure Pull outward to disengage the trim panel retainers. Disconnect the electrical connectors.