Rear Quarter Lower Trim Panel Replacement (Acadia/Outlook without E61)

Fig 1: Identifying Rear Quarter Lower Trim Panel (Acadia/Outlook Without E61)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Move the rear seat to the full forward position. Remove the rear number 2 seat. Refer to Rear Number 2 Seat Replacement . Remove the rear quarter upper trim panel. Refer to Rear Quarter Upper Trim Panel Replacement (without RPO E61) or Rear Quarter Upper Trim Panel Replacement (with RPO E61) . Disconnect the liftgate actuator rod from the liftgate. Refer to Liftgate Actuator Rod Replacement . Disconnect the rear seat number 2 shoulder belt anchor bolt. Refer to Rear Seat Number 2 Retractor Side Belt Replacement .
1	Cargo Tie Down Loop Bolt Cap (Qty: 2)
2	Cargo Tie Down Loop Bolt (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 3 N.m (27 lb in)
3	Cargo Tie Down Loop (Qty: 2)
4	Body Side Trim Panel Armrest Tip: Pull upward on the armrest to disengage the retainer clips.
5	Cargo Screen Retainer Assembly Tip: Twist and pull outward to remove the retainer.
6	Rear Quarter Lower Trim Panel Bolt (Qty: 2) Tighten: 3 N.m (27 lb in)
7	Rear Quarter Lower Trim Panel Assembly Procedure Pull outward to disengage the trim panel retainers. Disconnect the electrical connectors.