LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2008 >> Acadia SLT, FWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Front Side Door Wiring Harness Replacement >> Removal Procedure

Removal Procedure

  1. Disable the SIR. Refer to SIR Disabling and Enabling .
  2. Remove the side front door trim panel. Refer to Front Side Door Trim Panel Replacement - Left Side (Acadia) or Front Side Door Trim Panel Replacement - Left Side (Enclave) or Front Side Door Trim Panel Replacement - Left Side (OUTLOOK) or Front Side Door Trim Panel Replacement - Right Side (Enclave) or Front Side Door Trim Panel Replacement - Right Side (OUTLOOK) or Front Side Door Trim Panel Replacement - Right Side (Acadia) .
  3. Remove the front door speaker. Refer to Radio Front Side Door Speaker Replacement .
  4. Remove the front water deflector. Refer to Front Side Door Water Deflector Replacement .
  5. Disconnect the regulator motor electrical connector.
  6. Disconnect the door latch assembly electrical connector.
  7. Disconnect the electrical connector from the SIR side impact sensor.
    8. Fig 1: Body Harness Inline Electrical Connector
    GM735194Courtesy of GENERAL MOTORS CORP.
  8. Disconnect the body harness inline electrical connector by releasing the connector retaining tab located on the body side of the connector.
  9. Remove the front door wiring harness electrical connector from the mounting bracket by releasing the mounting bracket retaining tab located on the hinge side of the connector.
  10. Remove the rubber grommet from the door access opening.
    11. Fig 2: Wiring Harness Routing
    GM735195Courtesy of GENERAL MOTORS CORP.
  11. Note the routing of the front door wiring harness and release the wire harness attachments from the door.
  12. Pass the front door wiring harness electrical connector through the access opening and remove the front door wiring harness from the door.
scientia non olet · About LEMON Manuals