LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2008 >> Acadia SLT, AWD >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 6T70/6T75 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Transmission Control Lever Knob Replacement (Enclave) >> Installation Procedure

Installation Procedure

  1. Apply lubricant P/N 88861426 to the tip of the shift control lever.
    2. Fig 1: Identifying Shift Control Knob
    GM1866663Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Carefully guide the transmission tap up/tap down switch electrical harness and connector past the shift control indicator while installing the shift control knob.
  2. Install the shift control knob (1) to the shift control lever.
    3. Fig 2: Identifying Shift Control Knob Screw
    GM1866661Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the control knob screw (1).

    Tighten:  Tighten the screw to 4 N.m (35 lb in).

  4. Lift the shift control knob trim ring (2) up to the shift control knob until a click sound is heard indicating the trim ring is secured to the shift knob.
  5. Place the shift control lever in the PARK position.
  6. Rotate the key to the off position.
    7. Fig 3: Identifying Transmission Tap Up/Tap Down Switch Electrical Connector
    GM1866658Courtesy of GENERAL MOTORS CORP.
  7. Connect the transmission tap up/tap down switch electrical connector (1).
  8. Check for proper operation of the shift control through all gear ranges.
  9. Install the floor console left extension panel. Refer to Front Floor Console Extension Panel Replacement - Left Side (Acadia) or Front Floor Console Extension Panel Replacement - Left Side (Enclave) or Front Floor Console Extension Panel Replacement - Left Side (Outlook) .
  10. Release the parking brake.
scientia non olet · About LEMON Manuals