Torque Converter Removal

Fig 1: View Of Torque Converter

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Lock Pin CAUTION: Lock pin must be secured into the bench fixture to hold the transmission and prevent bodily injury. Tip: Ensure the J 3289-20 is mounted to a bench that is properly supported and will support the weight of the transmission assembly without tipping. J-39890 adapter and an engine stand can be used as an alternative method for supporting the transmission assembly during repairs. See Special Tools . Special Tools J 3289-20 Holding Fixture J-39890 Transmission Holding Fixture Adapter. See Special Tools .
2	J 21366 Converter Holding Strap. See Special Tools .
3	Dust Cover Bolts M10 x 25, model dependent (Qty: 2)
4	Dust Cover Push Pin, model dependant
5	Dust Cover, model dependant
6	Torque Converter Assembly NOTE: Only install the lift assist handles until it stops. Do not tighten. Over tightening the lift assist handles can cause damage to the torque converter housing. Tip: Failure to raise the torque converter straight up could damage the torque converter clutch lip seal inside the torque converter clutch assembly. Special Tool: J 46409 Torque Converter Lifting Handles. See Special Tools .