Torque Converter Installation
| Callout | Component Name |
|---|---|
| 1 | Torque Converter Assembly
NOTE:
Lower the torque converter straight down. Failure to lower the torque converter straight down could damage the torque converter clutch lip seal inside the torque converter clutch assembly. Special Tool: J 46409 Torque Converter Lifting Handles. See Special Tools . |
| 2 | J 21366
Converter Holding Strap. See Special Tools .
CAUTION:
The torque converter must be held to the torque converter housing by a retaining device such as shipping brackets. Without the retaining device, the torque converter may slide forward, disengaging the oil pump, or may fall completely out of the transmission causing personal injury and/or property damage.
|
| 3 | Dust Cover - Model Dependant |
| 4 | Dust Cover Push Pin - Model Dependant (Qty: 2) |
| 5 | Dust Cover Bolt - Model Dependant
NOTE:
Refer to Fastener Notice
.
Tighten: 75 N.m (37 lb ft) |