Output Speed Sensor and Valve Body Installation

Fig 1: View Of Output Speed Sensor & Valve Body

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	1-2-3-4 Clutch Fluid Passage Seal
2	A/Trans Output Speed Sensor Assembly
3	A/Trans Output Speed Sensor Assembly Bolt M6 x 25 NOTE: Refer to Fastener Notice . Tighten: 12 N.m (9 lb ft)
4	Control Valve Body Assembly
5	Manual Valve Tip: Align the manual valve to the detent lever assembly. Removing the manual shaft assembly pin will aid in aligning the manual valve to the detent lever. Install the manual shaft pin after the valve body assembly is installed using J 41229 , if it was not installed previously. See Special Tools . Refer to Manual Shift Detent Lever with Shaft Position Switch Assembly and Park Pawl Actuator Removal . Special Tool: J 41229 Manual Shaft Pin Installer. See Special Tools .