Clean and Inspect

Fig 1: Identifying Case Cover Assembly Components

Courtesy of GENERAL MOTORS CORP.

Clean and Inspect

Callout	Component Name
NOTE: After cleaning the transmission components, allow to air dry. Do not use cloth or paper towels in order to dry any transmission components. Lint from the towels can cause component failure. NOTE: Do not reuse cleaning solvents. Previously used solvents may deposit sediment which may damage the component. Preliminary Procedures Thoroughly clean the case cover assembly, including threads, with clean solvent. Clean gasket sealing surfaces. Remove all residual gasket material. Inspect all threaded holes. If necessary, repair any thread damage.
1	Gasket Sealing Surface
2	Fluid Passages
3	Piston Bores
4	Cover to Case Passages
5	A/Trans Input Speed Sensor Assembly Bore
6	Cover Casting
7	Passage Cup Plugs
8	Input Shaft Support Bolts Tighten: Tightened bolts in sequence to 12 N.m (106 lb in).