Service Fast Learn Adapts: Troubleshooting

If the Service Fast Learn Adapts will not run and the above stated conditions have been met, ensure the following:

• TFT is between 70-100°C (158-212°F).
• Brakes and brake switch are functioning properly.
• No active DTCs.
• Closed throttle and engine RPM increases above 1500 RPM while in Park Test Setup or at entrance of the test modes.
• Park/Neutral position switch is properly adjusted and functioning.
• Line pressure control is able to provide 1000 kPa and is within specifications.
• Vehicle is not moving, or vibrating excessively.
• Clutches are properly assembled.