Front Seat Front Finish Panel Replacement

Fig 1: View Of Front Seat Front Finish Panel

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Front Seat Adjuster Switch Mounting Plate Procedure Using a non-metallic flat-bladed tool, release the retainer tabs starting at the rear edge and working forward while pulling outward on the mounting plate. Disconnect the electrical connectors from the switch assemblies.
2	Front Seat Outer Recliner Finish Cover Screw (Qty: 3) NOTE: Refer to Fastener Notice . Tighten: 4 N.m (35 lb ft)
3	Front Seat Outer Recliner Finish Cover Tip: Release the snaps from the front seat adjuster shield and the inner recliner cover while pulling outward to remove.
4	Front Seat Adjuster Shield
5	Front Seat Adjuster Shield Retainer Clip (Qty: 4)