Rear Side Door Trim Panel Replacement (Enclave)

Fig 1: Identifying Rear Side Door Trim Panel (Enclave)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Rear Side Door Pull Handle Cover
2	Rear Side Door Inside Handle Bezel Finish Cover
3	Rear Side Door Trim Panel Screw (Qty: 3) NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)
4	Rear Side Door Locking Rod Knob Assembly Procedure Ensure the locking rod is in the unlocked position. Use a flat-bladed tool to disengage the detent tab and then remove the knob by pulling upward. When re-installing, push the knob down until the detent tab touches the locking rod opening cover. Push the detent tab into the lock knob to locking rod.
5	Rear Side Door Trim Panel Assembly Procedure Use a door trim pad removal tool to aid in the removal of the trim panel. Disengage the door lock cable. Disconnect the electrical connector.
6	Rear Side Door Trim Panel Retainer (Qty: 9)