LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2008 >> Acadia SLE, AWD >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 6T70/6T75 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Transmission Fluid Cooler Pipe Connector Replacement - Radiator >> Installation Procedure

Installation Procedure

  1. Inspect the new O-ring seals for cracks, cuts or damage. Replace if necessary.
    2. Fig 1: View Of Oil Cooler Fitting At Radiator
    GM1443001Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
    IMPORTANT: The correct thread engagement is critical. Cross-threaded fittings can achieve proper tightness and still leak.
  2. Install the oil cooler fitting to the radiator.

    Tighten:  Tighten the fittings to 20 N.m (15 lb ft).

  3. Install the transaxle oil cooler hoses to the oil cooler fittings on the radiator. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .
  4. Fill the cooling system. Refer to COOLING SYSTEM DRAINING AND FILLING (VAC N FILL) or COOLING SYSTEM DRAINING AND FILLING (STATIC FILL) .
  5. Adjust the transmission fluid level.
  6. Inspect for fluid leaks.
scientia non olet · About LEMON Manuals