LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2008 >> Acadia SLE, AWD >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 6T70/6T75 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Automatic Transmission Range Selector Lever Cable Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Range Selector Lever Cable Terminal & Manual Shift Lever Pin
    GM1857737Courtesy of GENERAL MOTORS CORP.
  1. Install the transmission range selector lever cable to the vehicle.
  2. Install the transmission range selector lever cable grommet (6) to the cowl panel.
  3. Install the transmission range selector lever cable (2) to the cable bracket (3).
  4. Install the retainer (1) to the transmission range selector lever cable.
  5. Connect the transmission range selector lever cable terminal (4) to the transmission manual shift lever pin (5).
    6. Fig 2: Identifying Transmission Range Selector Lever Cable Terminal And Retainer
    GM1861752Courtesy of GENERAL MOTORS CORP.
  6. Install the transmission range selector lever cable to the transmission control lever base. Insure the cable retainer (2) is fully secured to the transmission control lever base.
  7. Connect the transmission range selector lever cable terminal (1) to the shift lever pin.
  8. Install the floor console left extension panel. Refer to Front Floor Console Extension Panel Replacement - Left Side (Acadia) or Front Floor Console Extension Panel Replacement - Left Side (Enclave) or Front Floor Console Extension Panel Replacement - Left Side (Outlook) .
  9. Adjust the automatic transmission range selector lever cable. Refer to Range Selector Lever Cable Adjustment .
  10. Release the parking brake.
scientia non olet · About LEMON Manuals