Torque Converter and Differential Housing Installation
| Callout | Component Name |
|---|---|
| 1 | Torque Converter Housing Outer Seal |
| 2 | Torque Converter and Support and A/Trans Fluid Pump Housing Assembly |
| 3 | Torque Converter and Differential Housing Bolts M8 x 35 (Qty: 17)
NOTE:
Some bolt torques specifications are different. Over tightening the bolts at the 12, 15 and 17 positions in the sequence could cause damage to the case threads.
NOTE:
Refer to Fastener Notice
.
Tighten: Tighten in sequence to 36 N.m (27 lb ft). Tighten the 3 bolts at the 9 o'clock position as shown above (torque sequence 12, 15, 17) to 30 N.m (22 lb ft). |