Lift Plate and Holding Fixture Installation
| Callout | Component Name |
|---|---|
| 1 | DT-47811
Transmission Lift Plate. See Special Tools .
CAUTION:
Handle with care, the transmission assembly weighs over 200 lbs. Bodily injury could occur if not handled properly. Tip: After Installation of lift plate, raise the transmission with an overhead hoist. Tighten: 12 N.m (9 lb ft) Special Tool: DT-47811 Transmission Lift Plate. See Special Tools . |
| 2 | J-46625
Transmission Holding Fixture. See Special Tools .
NOTE:
Refer to Fastener Notice
. Tip: Adjust mounting block on fixture to match bosses on case, then tighten bolts to: Tighten: 13 N.m (10 lb ft) Special Tool: J-46625 Transmission Holding Fixture. See Special Tools . |