Fluid Seal Ring Installation
Courtesy of GENERAL MOTORS CORP. Fluid Seal Ring Installation
| Callout |
Component Name |
| 1 |
3-5 Reverse and 4-5-6 Clutch Fluid Seal Ring
Tip:
- Place J 46620-3 which is part of J-46620
over the case cover hub and adjust it so that only the bottom seal ring is exposed. See Special Tools .
- Place a NEW fluid seal ring onto J 46620-3 which is part of J-46620
. See Special Tools .
- Use J 46620-2 which is part of J-46620
to push the fluid seal ring down over J 46620-3 which is part of J-46620
into the hub ring groove. See Special Tools .
- Repeat the above steps to install all 4 seal rings, adjusting J 46620-3 which is part of J-46620
to the appropriate ring groove. See Special Tools .
Special Tool:
J-46620
Seal Installer. See Special Tools . |
| 2 |
Small Chamfer Up
NOTE:
Do not force J 46620-1 down over the seals as this will roll and damage the seals. The large chamfer is designed to fit over the over stretched seal. Use a hand to help shrink the seal if J 46620-1 is difficult to install over the seal rings.
Tip:
Install J 46620-1 which is part of J-46620
with the large chamfer end down over the fluid seal rings and leave J 46620-1 which is part of J-46620
on the seals for at least 60 seconds. See Special Tools . |
| 3 |
Large Chamfer Up
Tip:
- Install J 46620-1 which is part of J-46620
with the small chamfer end facing down for at least 60 seconds. See Special Tools . This will properly size the bottom seal ring.
- Leaving J 46620-1 which is part of J-46620
on the fluid seal rings for an extended period of time could cause a fluid leak on the initial clutch piston circuit until the seal rings warm up and expand to the proper dimension. See Special Tools .
|