LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2007 >> Yukon Denali >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - DTC P0218 To DTC P0961) >> DTC P0852 >> Circuit Description

Circuit Description

WARNING: This page is about a different variant/trim than selected.

The Park/Neutral Position (PNP) Switch is externally mounted on the transmission manual shaft. As the gear range selector lever is moved, the state of the P/N switch may change, causing the Park/Neutral Signal circuit to open or close. An open circuit or switch indicates a drive range and a high voltage signal at the engine control module (ECM). A closed circuit or switch indicates PARK or NEUTRAL and a low voltage, 0 volts, signal at the ECM.

The ECM uses the PNP Switch status in order to enable starter operation.

If the PNP switch signal indicates low when the vehicle is in motion for a specified length of time, DTC P0852 sets. DTC P0852 is a type C DTC.

scientia non olet · About LEMON Manuals