LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2007 >> Yukon Denali >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Transmission Fluid Auxiliary Cooler Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Auxiliary Oil Cooler, Bolts & Push Pins
    GM711677Courtesy of GENERAL MOTORS CORP.
  1. Install the auxiliary oil cooler to the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the bolts (1) and the push pins (2) that retain the auxiliary oil cooler to the radiator brace.

    Tighten:  Tighten the bolts to 12 N.m (9 lb ft).

  3. Connect the transmission oil cooler lines to the auxiliary cooler. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Replacement .
  4. Install the front grill assembly. Refer to Fascia Grille Replacement (Suburban) or Fascia Grille Replacement (Yukon) or Fascia Grille Replacement (Escalade) or Fascia Grille Replacement (Tahoe Z71) .
scientia non olet · About LEMON Manuals