Front Output Shaft
WARNING: This page is about a different variant/trim than selected.
- Clean the front output shaft in cleaning solvent and air dry.
- Inspect the teeth on the speed sensor reluctor wheel (3) for damage.
- Replace the speed sensor reluctor wheel if it is damaged. Refer to Transfer Case Disassemble and Transfer Case Assemble .
- Inspect the front output shaft rear bearing race (1) for the following conditions:
- Scoring
- Pitting
- Brinelling
- Excessive wear
- Inspect the front output shaft splines (2) for damage.
- Replace the front output shaft if any of the above conditions are found.