LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2007 >> Yukon Denali >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Transfer Case - NVG 246-NP8) >> Diagnostic Information and Procedures >> Transfer Case High/Low Clutch Reset >> Using the transfer case shift control switch

Using the transfer case shift control switch

WARNING: This page is about a different variant/trim than selected.
  1. Place the switch into the AWD mode.
  2. Turn the switch clockwise past 4 low into the neutral request mode and hold for 30 seconds.
  3. After 30 seconds immediately turn the switch back into the AWD mode, an audible noise from the motor should occur indicating a successful learn procedure.
scientia non olet · About LEMON Manuals