LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2007 >> Yukon Denali >> Repair and Diagnosis >> External Pages >> Different car >> Section 892 (Automatic Transmission - 4L80-E/4L85-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Turbine Shaft Disassemble

Turbine Shaft Disassemble

WARNING: This page is about a different car, the 2007 GMC Yukon XL and 2007 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Inspection Areas On Turbine Shaft
    GM31139Courtesy of GENERAL MOTORS CORP.
  1. Remove the turbine shaft rear (501) and intermediate (503) oil seal rings.
  2. Inspect the turbine shaft (502) for damage or cracks.
  3. Inspect the turbine shaft plug (534) on the end of the turbine shaft (502).
scientia non olet · About LEMON Manuals