Ignition and Start Switch Housing Replacement
Ignition and Start Switch Housing Replacement
| Callout | Component Name |
|---|---|
| Preliminary Procedure: Remove the turn signal switch bracket. Refer to Turn Signal Switch Bracket Replacement . |
|
| 1 | Ignition/Start Switch Housing Bolt
NOTE:
Refer to Fastener Notice
.
Tighten: 8 N.m (71 lb in) |
| 2 | Ignition/Start Switch Housing Strap |
| 3 | Ignition/Start Switch Housing Procedure: Disconnect any electrical connectors as needed. |