Circuit/System Verification
- Ignition ON, with all doors closed, observe the scan tool Left Rear Door Ajar Switch parameter and Right Rear Door Ajar Switch parameter while opening and closing the rear doors. The reading should change between Door Closed and Door Ajar.
- If the value does not change, refer to Rear Door Ajar Switch Malfunction .
- Observe the scan tool Driver Door Ajar Sw parameter and Passenger Door Ajar Sw parameter while opening and closing the driver door and front passenger door. The reading should change between Active and Inactive.
- If the value does not change, refer to Front Door Ajar Switch Malfunction .