LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2007 >> Acadia SLE, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays And Gauges >> Diagnostic Information and Procedures >> Driver Information Center (DIC) Switch(es) Inoperative >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the DIC switch assembly.
  2. Ignition OFF, test for less than 1 ohm of resistance between the ground circuit and ground.
    • If greater than 1 ohm, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify all of the scan tool DIC Switch parameters are Inactive.
    • If any are not Inactive, test the signal circuit for a short to ground. If the circuit tests normal, replace the IPC
  4. Ignition ON, install a 3-amp fused jumper wire between the signal circuit and ground. Verify all of the scan tool DIC Switch parameters are Active.
    • If any are not Active, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the IPC.
  5. If all the circuits test normal, test or replace the DIC switch assembly.
scientia non olet · About LEMON Manuals