Transfer Case Control Schematic Icons

WARNING: This page is about a different variant/trim than selected.

Icon	Icon Definition
Courtesy of GENERAL MOTORS CORP.	IMPORTANT: Twisted-pair wires provide an effective shield that helps protect sensitive electronic components from electrical interference. Depending on application, twisted-pair wires are used on wiring harnesses connecting the following components: The electronic ignition (EI) control module The manifold absolute pressure (MAP) sensor The powertrain control module (PCM) The vehicle speed sensor (VSS) In order to prevent electrical interference from degrading the performance of the connected components, you must maintain the proper specification when making any repairs to the twisted-pair wires shown : The wires must be twisted a minimum of 9 turns per 30.5 cm (12 in) as measured anywhere along the length of the wires. The outside diameter of the twisted wires must not exceed 6.0 mm (0.236 in). Refer to Splicing Twisted or Shielded Cable in Wiring Systems.

Icon

Icon Definition

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Twisted-pair wires provide an effective shield that helps protect sensitive electronic components from electrical interference. Depending on application, twisted-pair wires are used on wiring harnesses connecting the following components:

The electronic ignition (EI) control module
The manifold absolute pressure (MAP) sensor
The powertrain control module (PCM)
The vehicle speed sensor (VSS)

In order to prevent electrical interference from degrading the performance of the connected components, you must maintain the proper specification when making any repairs to the twisted-pair wires shown :

The wires must be twisted a minimum of 9 turns per 30.5 cm (12 in) as measured anywhere along the length of the wires.
The outside diameter of the twisted wires must not exceed 6.0 mm (0.236 in).

Refer to Splicing Twisted or Shielded Cable in Wiring Systems.