LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Yukon Denali >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Transfer Case - NVG 246-NP8 - Service & Diagnosis) >> Repair Instructions >> Transfer Case Speed Sensor Replacement - Left Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing Left Rear Speed Sensor
    GM163714Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the left rear speed sensor.

    Tighten:  Tighten the speed sensor to 15 N.m (11 lb ft).

    2. Fig 2: Identifying External Transfer Case Components
    GM829147Courtesy of GENERAL MOTORS CORP.
  2. Connect the left rear speed sensor electrical connector (4).
  3. Lower the vehicle.
scientia non olet · About LEMON Manuals