LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Yukon Denali >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Transfer Case - NVG 246-NP8 - Service & Diagnosis) >> Repair Instructions >> Transfer Case Shift Control Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Disconnecting Selector Switch Electrical Connectors
    GM830158Courtesy of GENERAL MOTORS CORP.
  1. Remove the instrument panel (I/P) cluster bezel. Refer to Bezel Replacement - Instrument Panel (I/P) Cluster in Instrument Panel, Gages, and Console.
  2. Using a flat-tipped screwdriver, gently pry the retaining clips open on the housing.
  3. Slide out the selector switch until the electrical connectors are accessible.
  4. Disconnect the selector switch electrical connectors (2, 3).
    5. Fig 2: Removing Selector Switch From Housing
    GM396838Courtesy of GENERAL MOTORS CORP.
  5. Remove the selector switch from the housing.
scientia non olet · About LEMON Manuals