LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Yukon Denali >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Transfer Case - NVG 246-NP8 - Service & Diagnosis) >> Repair Instructions >> Transfer Case Shift Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing Shift Control Module
    GM856631Courtesy of GENERAL MOTORS CORP.
  1. If a NEW control module is being installed, program the new module. Refer to Control Module References in Computer/Integrating Systems.
  2. Install the shift control module to the bracket.
    3. Fig 2: Disconnecting Shift Control Module Electrical Connectors
    GM885116Courtesy of GENERAL MOTORS CORP.
  3. Connect the shift control module electrical connectors.
  4. Start the engine and test the automatic transfer case system for proper shift operation.
scientia non olet · About LEMON Manuals