LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Yukon Denali >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Transfer Case - NVG 246-NP8 - Service & Diagnosis) >> Diagnostic Information and Procedures >> Transfer Case Shudder or Binding

Transfer Case Shudder or Binding

WARNING: This page is about a different variant/trim than selected.
Transfer Case Shudder or Binding

Cause Correction
DEFINITION: When in the AWD mode, a shudder is felt during acceleration or a crow-hop or binding while turning, which may cause tire scuffing.
Review the Symptoms - Transfer Case  and perform the necessary inspections.
Oil breakdown or contamination Flush the transfer case and fill with the correct fluid. Refer to Transfer Case Fluid Replacement .
Incorrect transfer case fluid Flush the transfer case and fill with the correct fluid. The active transfer case uses a blue fluid. Refer to Transfer Case Fluid Replacement .
Burrs on the clutch hub slots
  1. Inspect the clutch disc tab slots in the clutch hub for burrs or notches. Refer to Cleaning and Inspection  in Transfer Case - NVG 246-NP8 Unit Repair.
  2. De-burr the hub slots. If the hub slots are excessively notched, replace the clutch hub. Refer to Transfer Case Disassemble  and Transfer Case Assemble  in Transfer Case - NVG 246-NP8 Unit Repair.