Transfer Case Clunk in 2HI Only

WARNING: This page is about a different variant/trim than selected.

Cause	Correction
DEFINITION: During acceleration or deceleration, a clunk is heard or felt in the transfer case while in the 2HI mode. Review the Symptoms - Transfer Case and perform the necessary inspections.
Incorrect fluid level or incorrect fluid	Inspect the transfer case for the correct fluid level. Refer to Transfer Case Fluid Replacement . Inspect the transfer case for the correct type of fluid. Flush the transfer case and fill with the correct fluid, if required. Refer to Transfer Case Fluid Replacement .
Excessive clearance between the slip yoke and the rear output shaft	Inspect for the following conditions: Worn slip yoke splines Worn rear output shaft splines Repair or replace the following components if faulty: Replace the slip yoke, if required. Refer to Propeller Shaft Replacement - Rear in Propeller Shaft. Replace the rear output shaft, if required. Refer to Transfer Case Disassemble and Transfer Case Assemble in Transfer Case - NVG 246-NP8 Unit Repair.
Excessive clearance between the slip yoke and the rear bushing	Inspect for the following conditions: Worn rear bushing Worn slip yoke bushing journal Repair or replace the following components if faulty: Replace the slip yoke, if required. Refer to Propeller Shaft Replacement - Rear in Propeller Shaft. Replace the rear bushing if it is worn. Refer to Transfer Case Output Shaft Seal Replacement - Rear .
Worn high speed teeth on the range sleeve	Inspect for the following conditions: Worn high speed teeth on the range sleeve Worn or missing input gear thrust washers Refer toCleaning and Inspection in Transfer Case - NVG 246-NP8 Unit Repair. Repair or replace the following components if faulty: Replace the range collar if it is worn. Refer to Transfer Case Disassemble and Transfer Case Assemble in Transfer Case - NVG 246-NP8 Unit Repair. Replace the thrust washers as required. Refer to Transfer Case Disassemble and Transfer Case Assemble in Transfer Case - NVG 246-NP8 Unit Repair.
Rear output shaft bearing outer retaining ring	Inspect for the following conditions: Proper installation of the rear output shaft bearing retaining ring Excessive wear or damage to the retaining ring groove in the rear case half Repair or replace the following components if found faulty: Properly install a new rear output shaft bearing outer retaining ring. Replace the rear case half if the retaining ring groove is excessively worn. Refer to Transfer Case Disassemble and Transfer Case Assemble in Transfer Case - NVG 246-NP8 Unit Repair.