Installation Procedure

WARNING: This page is about a different car, the 2006 Cadillac Escalade EXT, 2006 Cadillac Escalade ESV, and 2006 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Vehicle Speed Sensor (VSS) & O-Ring Seal

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the speed sensor with a NEW O-ring.
Tighten: Tighten the sensor to 17 N.m (13 lb ft).

Fig 2: Transfer Case Components

Courtesy of GENERAL MOTORS CORP.

Connect the speed sensor electrical connector (4).
Lower the vehicle.