Tools Required

J 36850  Transjel® Lubricant

1. Install the overrun clutch housing thrust bearing assembly (513) into the overdrive carrier assembly (514). Retain with J 36850  or equivalent.
   Fig 1: Locating Overrun Clutch Housing Thrust Bearing Assembly

   Courtesy of GENERAL MOTORS CORP.
2. Install one overdrive carrier pinion gear (518) and its roller bearings (517) and thrust washers (515, 516), into the overdrive carrier assembly (514) at the location marked at disassembly.
   Fig 2: View Of Overdrive Carrier Pinion Gear Components

   Courtesy of GENERAL MOTORS CORP.
3. Install the overdrive carrier pinion gear pin (519).
4. Repeat steps 2 and 3 until all 4 pinion gear assemblies are installed in their original locations.
5. Install the overdrive carrier pinion gear pin retainer (520) on the overdrive carrier assembly (514). Align the pinion gear pins with the retainer slots.
   Fig 3: View Of Overdrive Carrier Assembly, Pinion Gear Pin Retainer, & Pin Retaining Ring

   Courtesy of GENERAL MOTORS CORP.
6. Install the overdrive carrier pinion gear pin retainer retaining ring (521) on the overdrive carrier assembly (514).