LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 6.6L - On Vehicle Repair Instructions) >> On-Vehicle Repair Instructions >> Turbocharger Oil Supply Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    IMPORTANT: Lubricate the NEW washer with diesel fuel before installing.
    NOTE: Refer to Fastener Notice .
  1. Position the oil feed pipe and a NEW washer into place.
  2. Install the oil feed pipe bolt.
    Fig 1: View Of Oil Feed Pipe Bolt, Washer & Pipe
    GM1335581Courtesy of GENERAL MOTORS CORP.

    Tighten:  Tighten the bolt to 34 N.m (25 lb ft).

  3. Install the turbocharger. Refer to Turbocharger Replacement .
scientia non olet · About LEMON Manuals