LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 6.6L - On Vehicle Repair Instructions) >> On-Vehicle Repair Instructions >> Positive Crankcase Ventilation (PCV) Valve Replacement (Left) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    IMPORTANT: After removing the charged air cooler duct, cover the turbocharger opening with tape in order to prevent entry of objects.
  1. Loosen the charged air cooler inlet duct connector to turbocharger clamp (1).
    2. IMPORTANT: Do not use a screwdriver or other tool to pry the hose loose. The hose can be torn or damaged. Loosen the hose by twisting.
    Fig 1: View Of Turbocharger Clamp & Charged Air Cooler Inlet Duct Connector
    GM1334380Courtesy of GENERAL MOTORS CORP.
  2. Remove the charged air cooler inlet duct connector (4) from the turbocharger.
  3. Remove the positive crankcase ventilation (PCV) cover screws.
  4. Remove the PCV cover, diaphragm, and spring.
    Fig 2: View Of PCV Cover, Diaphragm & Spring
    GM1336134Courtesy of GENERAL MOTORS CORP.
  5. Clean and inspect the cover, diaphragm, and spring.
  6. Discard the diaphragm if damage is found.
scientia non olet · About LEMON Manuals