LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 6.6L - On Vehicle Repair Instructions) >> On-Vehicle Repair Instructions >> Oil Level Indicator and Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install NEW O-ring seals onto the oil level indicator tube.
  2. Lightly lubricate the O-ring seals with engine oil.
  3. Install the oil level indicator tube.
    Fig 1: Oil Level Indicator Tube
    GM1602062Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  4. Install the oil level indicator tube bolt at the indicator tube bracket.

    Tighten:  Tighten the bolt to 21 N.m (15 lb ft).

  5. Install the starter motor. Refer to Starter Motor Replacement (6.6L (LLY) Engine) .
  6. Install the exhaust manifold. Refer to Exhaust Manifold Replacement - Right (6.6L (LLY) Engine) .
  7. Install the oil level indicator.
scientia non olet · About LEMON Manuals