LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 6.6L - On Vehicle Repair Instructions) >> On-Vehicle Repair Instructions >> Intake Manifold Replacement - Right >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the center intake manifold. Refer to Intake Manifold Replacement - Center .
  2. Remove the right fuel rail. Refer to Fuel Rail Assembly Replacement - Bank 1 .
  3. Remove the intake manifold bolts/nuts.
    4. IMPORTANT: The intake manifold uses sealer. Pry at the area by the fuel rail bolt holes in order to avoid damage to the sealing surfaces.
    Fig 1: View Of Intake Manifold (Right)
    GM1335935Courtesy of GENERAL MOTORS CORP.
  4. Remove the intake manifold.
  5. To prevent entry of debris in the cylinder head tape the openings.
  6. If required, clean and inspect the intake manifold. Refer to Intake Manifold Cleaning and Inspection .
scientia non olet · About LEMON Manuals