Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Apply a 2-3 mm (1/8 in) wide, by 0.5-1.5 mm (1/16 in) high bead of sealant GM P/N 97720043 (Canadian P/N 88901148), or equivalent to the intake manifold.

Fig 1: Determining Sealant Bead Dimensions
Courtesy of GENERAL MOTORS CORP.
Install the intake manifold.

Fig 2: View Of Intake Manifold (Right)
Courtesy of GENERAL MOTORS CORP.
Install the intake manifold bolts/nuts.

NOTE: Refer to Fastener Notice .

Fig 3: Identifying Intake Manifold Bolt Tightening Sequence (Right)

GM654532

Courtesy of GENERAL MOTORS CORP.

Tighten the intake manifold bolts/nuts in the sequence shown.
Tighten: Tighten the bolts/nuts to 21 N.m (15 lb ft).
Install the right fuel rail. Refer to Fuel Rail Assembly Replacement - Bank 1 .
Install the center intake manifold. Refer to Intake Manifold Replacement - Center .