LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 6.6L - On Vehicle Repair Instructions) >> On-Vehicle Repair Instructions >> Intake Manifold Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the intake manifold cover.
    Fig 1: View Of Intake Manifold Cover
    GM1334378Courtesy of GENERAL MOTORS CORP.
  2. Tighten the intake manifold cover bolt (2) until snug.
    3. NOTE: Refer to Fastener Notice .
  3. Tighten the intake manifold cover clamp (1) at the resonator.

    Tighten:  Tighten the clamp to 6 N.m (53 lb in).

scientia non olet · About LEMON Manuals