LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 6.6L - On Vehicle Repair Instructions) >> On-Vehicle Repair Instructions >> Engine Oil Pressure Sensor and/or Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Apply sealant GM P/N 12346004 (Canadian P/N 10953480), or equivalent to the threads of the oil pressure sensor.
    NOTE: Refer to Fastener Notice .
  2. Using J 41712  , install the oil pressure sensor (1).
    Fig 1: View Of Oil Pressure Sensor
    GM1364822Courtesy of GENERAL MOTORS CORP.

    Tighten:  Tighten the sensor to 30 N.m (22 lb ft).

  3. Connect the oil pressure sensor electrical connector.
    Fig 2: View Of Oil Pressure Sensor Electrical Connector
    GM1335546Courtesy of GENERAL MOTORS CORP.
  4. Install the left wheelhouse inner panel. Refer to Wheelhouse Panel Replacement .
  5. Check and add engine oil if necessary.
scientia non olet · About LEMON Manuals