Installation Procedure

WARNING: This page is about a different variant/trim than selected.

CAUTION: When removing, handling or installing this component wear protective gloves. The sharp edges on the component may be very sharp and may cause injury.

If necessary, install a NEW pilot bearing.

Fig 1: View Of Engine Flywheel Pilot Bearing
Courtesy of GENERAL MOTORS CORP.

CAUTION: When removing, handling or installing this component wear protective gloves. The sharp edges on the component may be very sharp and may cause injury.

IMPORTANT: When installing the flywheel, ensure that the tapered side of the teeth are facing the starter.

Install the flywheel.

NOTE: This component uses bolts with a preapplied molybdenum disulfide coating for thread lubrication. Do not remove the coating or use any additional lubricant. Improperly lubricated threads will adversely affect the bolt torque and clamp load. Improper bolt torque and clamp load can lead to engine damage.

Fig 2: View Of Flywheel & Bolts (Manual)

Courtesy of GENERAL MOTORS CORP.

Loosely install NEW flywheel bolts.

NOTE: Refer to Fastener Notice .

Fig 3: Flywheel Bolt Tightening Sequence

Courtesy of GENERAL MOTORS CORP.

Tighten the flywheel bolts in the proper sequence.
Tighten:
1. Tighten the bolts a first pass to 79 N.m (58 lb ft).
2. Tighten the bolts a second pass to 60 degrees using J 45059 .
3. Tighten the bolts a final pass an additional 60 degrees using J 45059 .
Install the starter motor. Refer to Starter Motor Replacement (6.6L (LLY) Engine) .
Install the clutch. Refer to Clutch Assembly Replacement .