LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 6.6L - On Vehicle Repair Instructions) >> On-Vehicle Repair Instructions >> Engine Flywheel Replacement (Automatic Transmission) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission. Refer to Transmission Replacement (With 6.6L Engine) .
  2. Install J 44643  in order to hold the flywheel. See Special Tools .
    Fig 1: Locking Flywheel Using J 44643
    GM660308Courtesy of GENERAL MOTORS CORP.
    3. CAUTION: When removing, handling or installing this component wear protective gloves. The sharp edges on the component may be very sharp and may cause injury.
  3. Remove and discard the flywheel bolts.
  4. Remove the flywheel washer and flywheel.
    Fig 2: View Of Flywheel & Washer (Automatic)
    GM1334818Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals