Installation Procedure

WARNING: This page is about a different variant/trim than selected.

NOTE: Refer to Fastener Notice .

Fig 1: View Of Right Side Idler & Center Idler Pulley Bolts

Courtesy of GENERAL MOTORS CORP.

Install the right side idler pulley and bolt (1).
Tighten: Tighten the bolt to 50 N.m (37 lb ft).
Install the center idler pulley and bolt (2).
Tighten: Tighten the bolt to 50 N.m (37 lb ft).
If equipped with dual generators, install the left side idler pulley and bolt.
Tighten: Tighten the bolt to 50 N.m (37 lb ft).
Install the drive belt. Refer to Drive Belt Replacement .