LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 6.6L - On Vehicle Repair Instructions) >> On-Vehicle Repair Instructions >> Crankshaft Balancer Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Lubricate the crankshaft balancer internal hub with clean engine oil.
  2. Install the crankshaft balancer on the crankshaft.
    Fig 1: View Of Crankshaft Balancer & Bolt
    GM1334816Courtesy of GENERAL MOTORS CORP.
  3. Lubricate the crankshaft balancer bolt with clean engine oil.
    NOTE: Refer to Fastener Notice .
  4. Install the crankshaft balancer bolt and washer.

    Tighten: 

    1. Tighten the bolt a first pass to 100 N.m (74 lb ft).
    2. Tighten the bolt a second pass an additional 105 degrees.

  5. Remove J 44643  . See Special Tools .
    Fig 2: Locking Flywheel Using J 44643
    GM660308Courtesy of GENERAL MOTORS CORP.
  6. Position the starter motor.
    Fig 3: View Of Starter
    GM1334814Courtesy of GENERAL MOTORS CORP.
  7. Install the starter motor bolts.

    Tighten:  Tighten the bolts to 78 N.m (58 lb ft).

  8. Install the right wheelhouse panel. Refer to Wheelhouse Panel Replacement .
  9. Install the lower fan shroud. Refer to Fan Shroud Replacement - Lower .
  10. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) .
scientia non olet · About LEMON Manuals